Use the flow-export command to configure the export of data to NetFlow collectors.flow-export active-flow-timeout <1-30 minutes>flow-export destination {1 | 2} <Collector IP address> <Collector port>
no flow-export destination {1 | 2}flow-export engine-id <0-255>flow-export engine-type <0-255>flow-export traffic-type <lan-rx | lan-tx | wan-rx | wan-tx>
no flow-export traffic-type <lan-rx | lan-tx | wan-rx | wan-tx>
active-flow-timeout <1-30> Specifies the IP address and port for the NetFlow collector. You can configure up to two collectors.Use the no form of this command to disable the export of NetFlow records to either Collector 1 or Collector 2. engine-id <0-255> engine-type <0-255>
• 0 for RP, and
• 1 for VIP/LC. Use the no form of this command to turn off a specific interface’s flow exporting.The appliance lets you turn on up to four interfaces for flow exporting. However, you must specify each interface by using a separate command.(config) # flow-export destination 2 10.10.10.4 146(config) # flow-export destination 1(config) # flow-export traffic-type lan-rx
Please send comments or suggestions regarding user documentation to techpubs@silver-peak.com. |