system 10gigabit

Description

Use the system 10gigabit command to configure the appliance 10-Gigabit option.

Syntax

system 10gigabit {enable | disable}

Arguments

enable | disable

Globally enables or disables the 10-Gigabit option.

Defaults

None.

Command Mode

Global Configuration Mode

See Also

See the following related commands:

n	“system arp-table-size”

n	“system auto-ipid”

n	“system auto-subnet”

n	“system auto-syn”

n	“system auto-tunnel”

n	“system auto-tunnel allow”

n	“system bandwidth”

n	“system bonding”

n	“system bypass”

n	“system contact”

n	“system disk”

n	“system disk”

n	“system hostname”

n	“system location”

n	“system mode”

n	“system network-memory”

n	“system smb-signing”

n	“system ssl-ipsec-override”

n	“show system”

Usage Guidelines

This is applicable for platforms that have both 1Gbps and 10Gbps datapath interfaces. This includes the NX-9610, NX-8700, and NX-9700.

For example, the NX-9610 has 6 physical LAN/WAN interfaces and can run in one of two modes (either 4 x 1Gbps fiber interfaces or 2 x 10Gbps fiber interfaces). Use this command to switch between them. Also this command requires a reboot.

Examples

n	To run the 2 x 10Gbps fiber interfaces:

(config) # system 10gigabit enable

 

n	To run the 4 x 1Gbps fiber interfaces:

(config) # system 10gigabit disable

 

Please send comments or suggestions regarding user documentation to techpubs@silver-peak.com.