system dpc

Description

Use the system dpc command to configure Dynamic Path Control (DPC) for this appliance.

Syntax

system dpc tunnel-fail-behavior {disable | fail-back | fail-stick}

Arguments

tunnel-fail-behavior <failover behavior>	If there are parallel tunnels and one fails, then Dynamic Path Control determines where to send the flows. There are three failover behaviors.
disable	When the original tunnel fails, the flows aren’t routed to another tunnel.
fail-back	When the failed tunnel comes back up, the flows return to the original tunnel.
fail-stick	When the failed tunnel comes back up, the flows don’t return to the original tunnel. They stay where they are.

Defaults

None.

Command Mode

Global Configuration Mode

See Also

See the following related commands:

n	“system 10gigabit”

n	“system arp-table-size”

n	“system auto-ipid”

n	“system auto-subnet”

n	“system auto-syn”

n	“system auto-tunnel”

n	“system auto-tunnel allow”

n	“system bandwidth”

n	“system bonding”

n	“system bypass”

n	“system contact”

n	“system disk”

n	“system dpc”

n	“system hostname”

n	“system igmp-snooping”

n	“system location”

n	“system mode”

n	“system nat-all-inbound”

n	“system nat-all-outbound”

n	“system network-memory”

n	“system registration”

n	“system routing”

n	“system smb-signing”

n	“system ssl-ipsec-override”

n	“show system”

Usage Guidelines

None.

Examples

None.

 

Please send comments or suggestions regarding user documentation to techpubs@silver-peak.com.