system routing

Description

Use the system routing command to configure interface routing.

Use the no form of this command to reset system-level routing information.

Syntax

system routing inline

system routing redundancy {default | none | lan-native | lan-native-vlan | lan-and-wan | all}

no system routing inline

Arguments

inline	Enables inline router mode.
redundancy	Configures redundancy of routes between interfaces.
default	LAN routing allowed between VLANs and native interfaces (equivalent to lan-native-vlan)
none	No routing allowed between interfaces
lan-native	LAN routing allowed between native interfaces (no routing allowed between VLANs)
lan-native-vlan	LAN routing allowed between VLANs and native interfaces
lan-and-wan	LAN and WAN routing allowed between native interfaces
all	LAN and WAN routing allowed between all interfaces (caveat: this may disrupt DPC)

Defaults

None.

Command Mode

Global Configuration Mode

See Also

See the following related commands:

n	“system 10gigabit”

n	“system arp-table-size”

n	“system auto-ipid”

n	“system auto-subnet”

n	“system auto-syn”

n	“system auto-tunnel”

n	“system auto-tunnel allow”

n	“system bandwidth”

n	“system bonding”

n	“system bypass”

n	“system contact”

n	“system disk”

n	“system dpc”

n	“system igmp-snooping”

n	“system location”

n	“system mode”

n	“system nat-all-inbound”

n	“system nat-all-outbound”

n	“system network-memory”

n	“system registration”

n	“system smb-signing”

n	“system ssl-ipsec-override”

n	“show system”

Usage Guidelines

None.

Examples

None.

Please send comments or suggestions regarding user documentation to techpubs@silver-peak.com.