Configuring WCCP on A2

For an Active-Active deployment, we’ll configure the four WCCP Service Groups on A2 with the same options and values used for A1:

n	To ensure that this appliance (IP address 10.110.31.101) shares the traffic equally with A1, we’ll also accept the default weight of 100.

n	Note that Service Groups with outbound redirection use lan-ingress, and Service Groups with inbound redirection use wan-ingress.

n	Across all groups, the Router IP Address is 10.110.31.1.

w	To configure WCCP on A2

You’ll be completing the same steps as you did for configuring the A1 appliance. For a review, see “Configuring WCCP on A1”.

1	Go to Configuration - WCCP and select Enable WCCP.

2	Create two Service Groups for outbound redirection.: 53 for TCP, and 54 for UDP

3	Create two Service Groups for inbound redirection.: 55 for TCP, and 56 for UDP

4	Verify that the State of each WCCP Service Group changes from INIT to ACTIVE.

Summary of WCCP Active-Active Configuration on Appliances A1 and A2

	Service Groups: Outbound Redirection		Service Groups: Inbound Redirection
	53 (TCP)	54 (UDP)	55 (TCP)	56 (UDP)
Admin	up	up	up	up
Protocol	tcp	udp	tcp	udp
Advance Settings:
Forwarding Method	either	either	either	either
Weight (default)	100	100	100	100
Assignment Method	either	either	either	either
Force L2 Return	deselected	deselected	deselected	deselected
Password	optional	optional	optional	optional
Assignment Detail	lan-ingress	lan-ingress	wan-ingress	wan-ingress
Interface	wan0	wan0	wan0	wan0
Compatibility Mode	dependent on your router [default is IOS-compatible]
Router IP address	10.110.31.1

Please send comments or suggestions regarding user documentation to techpubs@silver-peak.com.