Web Search
Silver Peak
Preface
Who Should Read This Manual?
Manual Organization
Related Publications
Technical Support
Fundamentals of Deploying WAN Optimization
Introduction
Using Physical and Virtual Appliances
Choosing an Optimization Strategy for the Traffic Path
Configuring Dynamic Path Control
WAN Hardening
Determining the Need for Traffic Redirection
High Availability
Considerations for Deployments
Verifying Connectivity After Configuring Deployment
In-Line Deployment
Overview
Using the Initial Config Wizard
Verifying Appliance Connectivity
Creating Tunnels
Verifying Traffic
Out-of-Path with Policy-Based-Routing Redirection
SECTION 1: Using Subnet Sharing
Overview
Using the Initial Config Wizard
Verifying Appliance Connectivity
Enabling Subnet Sharing
Creating Tunnels and Updating the Subnet Table
Configuring the Router to Redirect Traffic
Verifying Traffic
SECTION 2: Using TCP/IP–based Auto-Optimization
Overview
Using the Initial Config Wizard with Site A’s Appliance
Configuring the Router for Policy-Based Routing (PBR)
Configuring a Tunnel to the Remote Site
Configuring Site B’s Appliance
Out-of-Path with WCCP
Overview
Configuring the Site A Router for WCCP
Using the Initial Config Wizard with Site A’s Appliance
Configuring WCCP on Appliance A
Using the Initial Config Wizard with Site B’s Appliance
Verifying Appliance Connectivity
Enabling Subnet Sharing
Creating Tunnels and Updating the Subnet Table
Verifying Traffic
Best Practices
Out-of-Path with VRRP Peering to a WAN Router
Overview
Using the Initial Config Wizard
Verifying Appliance Connectivity
Enabling Subnet Sharing
Creating Tunnels
Configuring VRRP on a Cisco Router
Configuring VRRP on Silver Peak A1
Verifying Traffic
Out-of-Path with PBR and VRRP Redundant Silver Peak Appliances
Overview
Using the Initial Config Wizard for Site A
Configuring VRRP on A1 and A2
Configuring Flow Redirection
Using the Initial Config Wizard with Site B
Verifying Appliance Connectivity
Enabling Subnet Sharing
Creating Tunnels and Updating the Subnet Table
Configuring A1 and A2 to Advertise Non-Local Subnets
Configuring the Cisco Router for Policy-Based Routing (PBR)
Verifying Traffic
Out-of-Path with WCCP Redundant (Active/Active) Appliances
Overview
Configuring the Site A Router for WCCP
Using the Initial Config Wizard with A1
Configuring WCCP on A1
Using the Initial Config Wizard with A2
Configuring WCCP on A2
Configuring Flow Redirection
Using the Initial Config Wizard with B
Verifying Appliance Connectivity
Enabling Subnet Sharing
Creating Tunnels
Configuring A1 and A2 to Advertise Non-Local Subnets
Verifying Traffic
Best Practices