Silver Peak SD-WAN Deployment Guide

Add Appliances

After configuring OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. and your overlays, you can deploy your appliances. OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. MUST be configured and deployed before you connect any EdgeConnect appliance.

OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. can automatically detect your appliances, or you can deploy them manually. You can find a Quick Start Guide for your specific appliance from our documentation page at Silver Peak User Documentation.

To Add Appliances using EdgeConnect

1. After following the instructions given in the Quick Start Guide, connect the mgmt0 port to a DHCPDynamic Host Configuration Protocol. A TCP/IP protocol that enables PCs and workstations to automatically get temporary or permanent IP addresses (out of a pool) from centrally administered servers. capable switchA network device that filters and forwards frames based on the destination address of each frame. The switch operates at Layer-2 (data link layer) of the Open System Interconnection (OSI) model. port and power the unit on.

   DO NOT connect any LANLocal Area Network. or WANWide Area Network ports until approved, licensed and configured.

2. Log into OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network..

   OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. and the appliance both contact the Silver Peak Cloud portal. This might take a couple of minutes.

   When successful, the Appliances Discovered button appears at the top of the page.

3. Click Appliances Discovered.

   

4. For each appliance you want to manage, click Approve.

   The Appliance Setup Wizard appears.

5. Follow the wizard using the IPInternet Protocol. Network layer protocol in the TCP/IP stack that enables a connectionless internetwork service. addresses you identified in Deployment Parameters.

After the appliance is licensed, approved, and configured, schedule the downtime needed to connect the Silver Peak to the appropriate WANWide Area Network connection points.