Silver Peak SD-WAN Deployment Guide

Configuring Orchestrator

The first time you log into OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network., the Getting Started Wizard automatically appears.

• After initial configuration, you can change your initial settings using the OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. interface.
• To change the Admin password, use the Getting Started Wizard. To restart the wizard, go to the OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. Administration tab, Under General choose Getting Started Wizard.

To run the Getting Started Wizard

When you have acquired your licenses, you are ready to configure OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network..

1. Within a browser, open OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network.. Use the IPInternet Protocol. Network layer protocol in the TCP/IP stack that enables a connectionless internetwork service. address that you set up for this purpose. The Sign in page appears.

2. Enter the username and password, then click Login.

   The default username and password is admin.

   The Getting Started Wizard appears.

3. The first page of the wizard shows the Host name, DHCPDynamic Host Configuration Protocol. A TCP/IP protocol that enables PCs and workstations to automatically get temporary or permanent IP addresses (out of a pool) from centrally administered servers., and Password.

   

   • Choose Static to enter the IPInternet Protocol. Network layer protocol in the TCP/IP stack that enables a connectionless internetwork service. address manually (recommended best practice).
   • CHANGE THE PASSWORD to a non-guessable password and put it somewhere secure. Leaving the default password could cause your network to be vulnerable to hackers.
4. Enter the License number, Account Name, and Account Key given to you by Silver Peak. See License & Account Key.

5. Click Next.

   OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. sends the License, Account Name, and Account Key to the Cloud PortalThe Silver Peak internet portal. All devices must be able to connect to the Cloud Portal to take advantage of Silver Peak features. and sends back a Registered message when successful.

   To verify, go to OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network. Administration > Silver Peak Cloud PortalThe Silver Peak internet portal. All devices must be able to connect to the Cloud Portal to take advantage of Silver Peak features. to view the registration status. It should read Registered = Yes.

6. Continue through the wizard until you are Done.

For more information:

• See the Unity Orchestrator Operator's Guide for a more thorough discussion of this topic.
• Within OrchestratorFormerly GMS. Silver Peak global management software. Manages, provisions, and monitors Silver Peak devices within a network., click the Question Mark on the page for details about each field.